Audi A1 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi. A couple of questions. I have an a1 1.6 diesel and one of the injectors is leaking. Fuel pooling around injector where it goes into the engine. I suspect either the seal or the return pipe is leaking. The return is a little looser than I would expect

I removed all pipes and plug from injector 3 and 4 but couldn’t get any further as I didn’t have a torx bit to remove the bracket that sits between them. So

1) do I need to remove that bracket to get injectors out?

2) how difficult are they to get out by hand

3) is the seal basically a copper washer that can be replaced (I ask because it is on my van)
4) if I replace the injector if needed. Does the new injector need to be coded to the car or is it just plug and play?
TIA
 
1 - 1 of 1 Posts
Top