Page 1 of 1

Retro fitting xenon Audi a1 Sportback

PostPosted: Sat Oct 15, 2016 8:33 am
by AudiA18xa
Retro fitting audi a1 xenon
Where shall the wiring goes from the adapter cabels to the BCM/control box, i Cant find Any where to but them in so the high beam Will work

Sendt fra min SM-G935F med Tapatalk

Re: Retro fitting xenon Audi a1 Sportback

PostPosted: Wed May 10, 2017 12:15 am
by kyriazog
I guess it is too late, but I should reply. The bcm which is located on the driver side near the relay place, has 3 connectors. You have to connect those two wires, on one of the connectors. I think it was the middle one, in places 48 and 49. You should find a copy of elsawin, and the info is in there. I will be doing this retrofit in aproxx. 3 months when my car arrives.